| Products & Datasheets >
Dulux Trade >
Specialist products >
Dulux Trade Blockfiller + |
 |
Dulux Trade Blockfiller + |
A water-based material which is suitable for interior use on concrete surfaces. It is designed to fill surface imperfections in concrete blocks and poured concrete and upgrades the appearance of the substrate. |
Key information
| Formulation |
Water-based |
| Coverage |
Up to 5m² per litre |
| Touch dry |
1 hour dependent upon temperature / humidity |
| Recoatable |
4 hours |
| Pack sizes |
10L |
| Thinning |
Do not thin this product. |
| Location |
Interior |
| Application |
Brush, Roller, Conventional Spray, Airless Spray |
Key benefits
- One coat opacity saves time and money.
-
Ideal where minimum downtime and a cost efficient system is required.
-
Fills minor imperfections to act as a finish or primer for subsequent coats of paint.
System information
To get the best results, make sure surfaces to be painted are clean, dry and free from all defective or poorly adhering material, dirt, grease and salts.
The preferred method of application is to apply a full, generous coat by airless spray followed immediately by tipping off with a medium pile roller. When applying by spray work the Blockfiller Plus into all pores and voids with the first pass then finish with a full coat of Dulux Trade Blockfiller Plus.
On concrete block and poured concrete, after surface preparation apply one coat of the Blockfiller Plus, which can be left un-topcoated or finished with an appropriate Dulux trade system matched to the substrate and environmental conditions.
After use remove as much paint as possible from the equipment before cleaning with clean water.
Top Trade Tip
Can also be applied by brush, roller or conventional spray. If applying by brush, remove brush marks with a partially loaded roller while the filler is still wet.
|
Downloads
  |
